在啤酒生產過程中，工藝衛生是一個非常關鍵的環節。啤酒遭到污染后，會招致啤酒的口感不佳，嚴重時還會使啤酒變酸蛻變，形成經濟上的損失。為了保證良好的生產環境，釀酒設備的清洗和是必不可少。CIP清洗系統是為常用的清洗和的設備，其操作簡單、清洗和徹底。
In the process of beer production, technological hygiene is a very key link. After the beer is polluted, it will lead to the bad taste of the beer, and when it is serious, it will make the beer sour and degenerate, forming economic losses. In order to ensure a good production environment, it is necessary to clean and sterilize the brewing equipment. CIP cleaning system is the most commonly used equipment for cleaning and sterilization, which is simple in operation, thorough in cleaning and sterilization.
清洗的目的和作用是肅清罐壁、管道上的酵母、蛋白質凝固物、酒花樹脂、草酸鹽、酒石酸鹽、碳酸鹽等有機物和無機物，避免啤酒生產中的非生物污染;的目的和作用是運用適宜的劑能夠殺滅細菌、真菌等微生物，避免啤酒生產中的生物污染。
The purpose and function of cleaning is to eliminate the yeast, protein coagulate, hops resin, oxalate, tartrate, carbonate and other organic and inorganic substances on the tank wall and pipeline, so as to avoid non biological pollution in beer production; the purpose and function of sterilization is to use appropriate bactericide to kill bacteria, fungi and other microorganisms, and avoid biological pollution in beer production.
糖化設備的衛生：常溫下，先用清水進行10min的預沖洗;然后配置1%～2%氫氧化鈉溶液，加熱到80～85℃進行CIP循環30min;接下來用90～95℃的熱水進行CIP循環30～40min。
Sanitation of saccharification equipment: at room temperature, first rinse with clear water for 10min; then prepare 1% - 2% sodium hydroxide solution, heat to 80-85 ℃ for CIP circulation for 30min; then use 90-95 ℃ hot water for CIP circulation for 30-40min.
發酵設備的衛生：發酵罐衛生情況好壞對啤酒的質量影響很大，清潔無菌是發酵罐根本的請求。
Sanitation of fermentation equipment: the sanitation of fermentation tank has a great influence on the quality of beer, and the most fundamental request of fermentation tank is to clean and asepsis.
常溫下，直接用清水沖洗;然后配置2%～4%的堿溶液，加熱到80～85℃進行進行CIP循環30min;然后用清水進行沖洗5～10min，接下來配置1%～2%的硝酸或硫酸溶液在常溫下CIP循環30min;再用清水進行沖洗5～10min，常溫下配置0.35%～0.5%的劑進行CIP循環30min，后用無菌水進行沖洗去掉剩余的劑。
Under normal temperature, wash directly with clear water; then prepare 2% - 4% alkali solution, heat to 80-85 ℃ for CIP circulation for 30min; then wash with clear water for 5-10min, then prepare 1% - 2% nitric acid or sulfuric acid solution for CIP circulation for 30min under normal temperature; then wash with clear water for 5-10min, configure 0.35% - 0.5% bactericide at normal temperature for CIP circulation for 30min, and finally use sterile water for CIP circulation. Rinse to remove the remaining fungicide.
麥汁冷卻器的衛生：普通啤酒廠對麥汁冷卻器都進行堿洗，其清洗的頻率需求布置妥當，由于麥汁冷卻時會凝固析出相當多的蛋白質、酒花樹酯等，積聚在冷卻板之間防礙熱交流效果、降低冷卻流量，隨之而來啤酒的質量也遭到影響，諸如色度加深、苦澀味加重等。堿洗過后，用熱清水洗掉剩余的堿液。
Health of wort Cooler: ordinary breweries carry out alkali washing for wort coolers, and the frequency of cleaning is properly arranged. As wort will coagulate and precipitate quite a lot of protein, hops ester, etc. when it is cooled, it will accumulate between cooling plates to prevent the effect of heat exchange and reduce the cooling flow, and then the quality of beer will be affected, such as the deepening of color, the aggravation of bitter taste, etc. 。 After alkali washing, use hot water to wash off the remaining alkali liquor.
啤酒設備發酵罐的配置
Configuration of fermentation tank in beer equipment1.啤酒設備發酵罐的的人孔分為兩種 側人孔和上人孔總之都是給他清潔!
1. The manholes of fermentation tank of beer equipment are divided into two kinds: side manholes and upper manholes. In short, they are for him to clean!
2.排污口，排出啤酒或酵母!!
2. Drain outlet, discharge beer or yeast!!
3.CIP清洗這個就更不用說了，清洗發酵罐內側用的!
3. CIP cleaning, let alone cleaning the inside of fermentation tank!
4.取樣閥查看啤酒是不是曾經到達生產工藝及技術請求!
4. Check whether the beer has reached the production process and technical requirements by sampling valve!
以上是
不銹鋼內膽實木酒桶廠家為大家介紹的相關內容，本文來源：http://www.justeve.cnThe above is the relevant content introduced by the stainless steel inner solid wood barrel manufacturer. The source of this article is: http://www.justeve.cn
自動售酒機 2024-07-25 
